Adventurentals.com logo
home hike/camp/snow emergency beacons guidebooks contact us


Extracts from 406 MHz PLB/EPIRB user manuals:

McMurdo "Fastfind" PLB; Kannad "Safelink Solo" PLB


User manual extract - McMurdo and Kannad PLB (.PDF)

Turning the beacon ON

Turning the beacon OFF

Step by step diagram of turning on the McMurdo and Kannad PLBs Step by step diagram of turning off the McMurdo and Kannad PLBs

PLB Indicator light sequences

Diagram showing the McMurdo and Kannad PLB indicator lamp sequences



KTI "Safety Alert SA2G" PLB


User manual extract - KTI SA2G (.PDF)

Turning the beacon ON

Turning the beacon OFF

  1. Slide red protective cover down to expose the Red button (retain the red cover).
  2. Slide antenna end-piece forward to remove it from the recessed area on top of the beacon.
  3. Unwrap the antenna and adjust the antenna so that it stands upright.
  4. Press and hold the Red button until Green light starts to flash, and then release the button.
  5. Place or hold beacon in a clear area.
  1. Slide red protective cover back over the Red button to prevent reactivation of the beacon (secure with tape if necessary).
  2. Press Blue "Test" button until the strobe light ceases flashing.
  3. Wrap antenna around the beacon to its original position and secure the end of the antenna in the recessed area on the top of the beacon.



KTI Safety Alert SA1G EPIRB




Once activated

The SA1G will continue to transmit an updated GPS location every five (5) minutes.
The SafetyAlert SA1G has an in-built high intensity strobe light for visual detection at night or in poor visibility.



Want to know more?

Please see our emergency beacons page

Top of page